How to deploy the EPWCS

---

*Find a printable PDF version below.

Remove the EPWCS from its storage bag.

Lay the EPWCS out on the deck with the brand logo facing upwards.

Open the EBS carry bag and carefully remove the folded skin. Lay it out on the deck or gunwale ready for deployment.

Hold the tow rope up to keep it elevated. Pass the two stern ropes to the rider and have them pull the ropes under the PWC until the bow hood.

Instruct the rider to pull the Velcro straps up and over the seat, securing them snugly to each other.

Have the rider wrap the front rope (attached to the top of the bow hood) over the steering handlebars to keep the hood secure while idling. 

Note: This rope does not need to be tight; it simply holds the hood in place until you get underway.

Leave the two stern ropes trailing freely in the water and begin towing the disabled PWC back to shore.

Towing speeds depend on conditions, but a maximum of 15 knots is recommended for rider comfort. After use, hose the EPWCS with fresh water and hang it to dry thoroughly before storing it in the bag.

If you need additional help, please contact us at wayne@emergencyboatskins.com.au.

*Find a printable PDF version below.

Remove the EBS from the storage bag.

Place the EBS over the bow,  with the logo facing upwards. 

Secure the rope (located in the centre of the hood) to the boat. 

Drop the EBS into the water. 

Put your boat in gear and accelerate forward. 

As the EBS unrolls under the hull, you can adjust it by pulling it from either side of the vessel to ensure it covers the entire hull. 

Navigate safely back to shore,  but DO NOT exceed 15 knots. 

Once you have returned to shore, stop the boat and pull the EBS out from under the hull.

Hose the EBS using fresh water to remove the salt from the seawater. Hang the EBS out to dry thoroughly before rolling up and placing back into the storage bag. 

Stow the EBS with your safety equipment in a dark, dry place, where it is easily accessible.